INSERTION AND REMOVAL OF DRAWER BOX
Introducing the new designed flush filler panel, that will be shipped loose for ease of scribing to ceiling. After scribing the front filler piece, glue and connect the two pieces using the ¼ MDF unfinished spline on site, which makes a strong and even joint. The designer or installer can choose to have a flush reveal or 1/8” reveal to help with the design. This comes in horizontal grain only.
POSSIBLE REVEAL OPTION
- Depending on the orientation of the back piece, a 1/8” reveal can be created
- Since the parts ship loose, the installer can decide on site if they need the 1/8” reveal or flush reveal by rotating the back part accordingly
- The 1/8” reveal option is not possible with UV Lacquer since UV Lacquer is only available on one side.
STEP DESIGN, FLUSH DESIGN OR ACCENT TRIM
- Designers can choose between the old, step design or new, flush design, or Accent Trim
STEP DESIGN
FLUSH DESIGN
ACCENT TRIM
DESIGN OPTION
- Designers can choose to run to ceiling or leave open space
Benefits
- Designers can choose between step or flush design
- Parts shipped loose to provide ease of installing
- Easier to scribe
- Installer can create flush reveal or 1/8” reveal
- No mitre cuts
- Avoids dangerously sharp edges that can be easily dented
- Mitre cuts can also open up over time
- Banded on all edges
- Protects the panel from dents
- Design option to run to ceiling or leave open space
